STOLLE technology
Precision & tolerance accuracy are our business
The production of tooling plates from design and mould construction to casting and all the way to machine finishing is carried out completely in-house by STOLLE. STOLLE tooling plates are designed so that they are suitable for various surface loads and applications. The length, width, height and even the ribbing of the plates can be individually customised. In cases of extreme loads we offer an FEM calculation.
After the casting the plates are machined with high precision on CNC-controlled milling machines or on planing benches. An oil-proof and waterproof design with a bolted-on or milled oil channel can also be manufactured. Several tooling plates can be connected into a tooling plate field using the corresponding plate connectors. The set-up is carried out on proprietary adjustment elements that are selected according to the type of set-up and plate load capacity.
Put on the quality of STOLLE!
The recommended plate heights are specified for the corresponding m2load capacity in the following table.
| Load capacity | Plate height |
|---|---|
| up to 5 to/m² | 250 mm |
| up to 15 to/m² | 300 mm |
| up to 25 to/m² | 350 mm |
| up to 35 to/m² | 350 mm |
| up to 75 to/m² | 400 mm |
up to 150 to/m² | 450 mm |
| over 150 to/m² | 500 mm |
Normal ribbing
Reinforced ribbing
Version with oil channel
We will be glad to advise you.
Phone: +49 (0) 228 95033-0
E-Mail: info[at]stolle.net
To the contact form
AG 30 adjusting unit
The AG 30 adjusting unit is suitable for the stationary setting of tooling plates and for grouting with non-shrink grout. Each rib field has a grouting opening. The grout should be poured approximately 10 – 15 cm into the ribbing. Subsequent adjustment of the plate after the grout has been poured is not possible. The level screw and dust-cover are included in the scope of supply.
AE 55 alignment element
The AE 55 alignment element is suitable for loads up to 30 to/m2. The complete alignment element consists of a foundation anchor which is grouted into the concrete and the actual adjustment element which is screwed into the plates. With this element the plate can be firmly anchored in the foundation and precisely adjusted in regard to tension and pressure. The scope of delivery includes the complete element including the foundation anchor and steel cover for the tooling plate. Subsequent readjustment of the plate towards the machine base is possible at any time from the plate surface.
PST 24 plate connector
Individual plates can be combined into plate fields using bolts to produce a large flat clamping surface without any joints or edges as if cast from a single mould.
AE 82 / AES 82 alignment element
This alignment element is suitable for higher loads of over 30 up to approximately 100 to/m2. In the AES 82 version an additional steel bushing is pressed into the tooling plate and riveted to enable the alignment element to accept loads of more than 100 t/m2.
ST 30 regulating element
For set-up directly on the workshop floor where a plate working height that is as low as possible is desired. The plate is adjusted by altering the height of the square-head bolt. Other types of set-up are also possible as desired by the customer!
